Ok Sascha, in this case, my PCB is like the picture you sent.This was the Schematic on Bernards PCB and the Picture from you is the new.
@Sascha HelloTest of Power PCB V1.06 is OK with ESP8266 3.3V module.
R10 and R11 i use 4.7K . D3 is not mount.
Thanks Bernard and Sascha, OK for power pcb. Received components from Reichelt todayNö Changes in the powerpcb.
Hi Sascha and Bernard, just to let you know that for 69.90€ it's the charging station and the charger; already ordered.Is it charging station and charger for 69€? I do not know it at all more.
Here a picture:
Yes, for Sensors that need extra PullupsAre J3 and J30 Reserve ?
I'm not sure, think Reserve for Sensorsfor what are J27 and J36 used ?
Bonjour Laurent et Joyeux noel.R10Many things to do; change 100 Resistors with 010 ones on cards, to solder the condensator, to add pinconnectors on Teensy and esp32 etc... .
Sascha, if you do a next version of Power PCB, could ot be possible to add room between J11/J12 and INA226 card ? I can't connect J11 and J12 without pushing on INA card.
Also, I had to bore larger holes for D2 and D5.
Question: the two connections on INA226 cards with seperated pins shouldn't be connected with stronger pins, with stronger holes in PCB ? (the question also is what could be used in this case... didn't find strongers from Reichelt, with the same distance between both pins).
Don't hesitate to let me know if you see something wrong !![]()